How to spot a dark centre in a round diamond before you buy
A dark centre, which the trade also calls a nailhead, is a dull patch in the middle of the table that stays dark when the stone is tilted. GIA's research links it to a pavilion cut too deep, or to a crown and pavilion that do not match. In this model, a round with a 45 degree pavilion angle and 68.7% total depth has a dark, spoked centre, and the same round at 40.8 degrees and 61.9% stays bright.
Written by Carat Hunter, an independent diamond price comparison site that does not sell diamonds. Last checked against its sources on .
What does a good round look like?
Turn it. The centre is bright, and the small dark areas around it move as the stone moves. This round has a pavilion angle of 40.8 degrees.
Drag to turnThis model's figures
- Pavilion angle40.8°Good: A bright centre in this model
- Crown angle34.5°
- Table56%
- Depth61.9%
- Girdlemedium
- Culetpointed
Good and Watch mark whether a figure is inside or outside a range GIA or IGI publishes; where no range applies, the note describes the model only.
A dark centre and a bright round, side by side
One round of about 1 ct, modelled twice. Only the pavilion angle changes.
Drag to turn
Drag to turnWhat differs, in these models
Good: bright centre
- Pavilion angle40.8°Good: A bright centre in this model
- Depth61.9%
Poor: dark centre
- Pavilion angle45.0°Watch: A steep pavilion angle makes a dark centre more likely
- Depth68.7%
Good and Watch mark whether a figure is inside or outside a range GIA or IGI publishes; where no range applies, the note describes the model only.
Drag either stone; both turn together.
Modelled illustrations from one stone's measurements, not listings.
Why does a deep pavilion darken the centre?
GIA's research names a pavilion that is too deep as a cause of a dark centre. In real stones such a pavilion lets light escape instead of returning to the viewer, and the viewer's own reflection darkens the table too. In this model the deep pavilion sends the light that enters the centre of the table back toward the viewer, so the centre takes on the dark of the viewer's reflection.
Is a dark centre the same as a nailhead?
Often, yes. A GIA Lab Note calls nailhead 'a term often applied to a poorly cut stone that is dark on the table.' A report will not use the word, but for a standard round GIA's cut grade takes in the stone's pattern of bright and dark areas. Read the grade and watch the video together.
Fish-eye, dark centre or window?
All three make the middle of a diamond look wrong, and you tell them apart by what you see. GIA's research links a fish-eye to a pavilion cut too shallow and a dark centre to one cut too deep, and a window also comes from a shallow pavilion. The figures below are this site's models, not limits for real stones.
- Fish-eye
- A pale or grey ring just inside the edge of the table: the girdle, reflected. In this model it shows in a round with a 37 degree pavilion angle, 56.4% deep.
- Dark centre
- A dull patch in the middle of the table that stays dark when the stone is tilted. In this model it shows in a round with a 45 degree pavilion angle, 68.7% deep.
- Window
- A see-through middle that takes on the look of whatever is behind the stone. In this model it shows in an oval with a 36% pavilion depth, 53.6% deep.
In these models, the round with a 40.8 degree pavilion angle, 61.9% deep, shows neither a ring nor a dark centre, and the oval with a 44% pavilion depth, 61.6% deep, shows no window.
What to check on a listing
- Watch the video face up and rocking. A centre that stays dark at every angle is the one to walk away from.
- Depth. A round that is deep for its width may have a deep pavilion, or a thick girdle. The real point where a centre goes dark depends on the other angles too.
- Pavilion angle, when the report gives it. A steep angle makes a dark centre more likely.
On Carat Hunter
A round's page shows its depth and girdle as the report gives them, and its crown and pavilion angles when we have them. Lucy's take on a round can say when its depth is deeper than most rounds we track, which puts more of its weight below the girdle, and when its girdle runs very thick. The page cannot show the dark itself, so watch the video for a centre that stays dark.
Sources
- GIA 4Cs: Diamond Cut
- GIA 4Cs: GIA Diamond Cut Grade, 6 Things to Know
- GIA: GIA Researchers Evaluate ‘Light Performance’ and Diamond Cut
- GIA, Gems & Gemology, Fall 2004: A Foundation for Grading the Overall Cut Quality of Round Brilliant Cut Diamonds (Moses et al.)
- GIA, Gems & Gemology, Summer 2020 Lab Notes: Irradiated Blue Diamond with Interesting DiamondView Image
- GIA: Estimating a Cut Grade Using the GIA Diamond Cut Grading System